SIMBAD references

Context. Precision pulsar timing and studies of pulsar radio emission properties require accurate polarimetric calibration of the radio observations since incorrect calibration can distort profiles and introduce noise in time of arrival (TOA) data. In a previous article we presented a new method for calibrating pulsar observations conducted with the Nançay decimetric Radio Telescope (NRT), which significantly improved NRT polarimetric measurements and pulsar timing quality for data taken after this method was developed, in November 2019.
Aims. Results from the above-mentioned study hinted at a dependence of the polarimetric response of the NRT on the observed direction. We therefore investigated this potential dependence, since unaccounted variations in the instrumental response could degrade polarimetric measurements. Additionally, our aim was to develop a method for properly calibrating NRT pulsar observations conducted before November 2019.
Methods. We conducted three series of observations of bright pulsars over wide declination ranges, in a special observation mode in which the feed horn rotates by ∼180° degrees across the observation; this enabled us to determine the full polarimetric response of the NRT while modeling potential variations in calibration parameters with hour angle and declination. In addition, we developed a method that uses the measurement equation template matching (METM) technique to improve the calibration of pre-November 2019 data.
Results. From the analysis of the series of observations of bright pulsars with horn rotation, we found that the polarimetric response of the NRT does not appear to vary with hour angle or declination. On the other hand, the new METM-based calibration method appears to significantly improve the calibration of pre-November 2019 data. By analyzing NRT data on a selection of millisecond pulsars, we found that the new polarimetric profiles are more homogeneous, they generally have higher signal-to-noise ratios, and found that the TOA data for these MSPs are more accurate and contain lower levels of noise, especially when combining the new calibration method with the matrix template matching (MTM) method for extracting TOAs from pulsar observations.